|
|
- Remove the lower protection cover of a motive compartment, turn out a drain stopper and empty AT.
|
- Turn out 18 bolts of fastening of the pallet of a case of AT, remove the pallet and disconnect from it laying.
- Remove magnets and collect with their help metal particles from AT case pallet. Examine metal particles on a magnet and on the pallet – the steel particles which are (magnetized) indicate wear of bearings, gear wheels and washers, but not magnetized (copper or brass) – wear of plugs.
|
|
- Turn out 3 bolts and remove a maslozabornik with a sealing ring.
|
- Separate sockets of five Ý/m switching valves.
- Turn out a bolt, remove a lock plate and remove ATF temperature sensor (see the Section Replacement of Sensors).
- Release an electrical wiring from two holders.
|
|
- Turn out 17 bolts and remove assembly of valves.
|
|
|
Do not drop assembly of the control valve, a spring and the piston of the accumulator. |
|
|
- Remove the case of the control valve, a spring and three laying.
|
|
|
- Turn out 5 bolts and remove 5 Ý/m switching valves.
|
- Installation is made as it should be, the return to an order of dismantle of components, tighten fixture with the required efforts, use new laying and sealing rings.
|
|